CommodoresPlus

Didn’t even know there was a hill climb track there, live and learn

Whats the plan with the catch can Cav, you going to run it without the vented top for engineering, then change it over for “track” duties?

Mt Gambier is a great spot I reckon, used to love going there when my son was karting.  I assume that’s a dirt event?  So sounds like its getting pretty sorted now?

Been away overseas (Thailand) over Christmas, but back now.  Gotta say I am a little frustrated how long this is all taking but I think that has more to do with me being an impatient bastard than anything else!!

Got sent the 3D pdf file of my pistons, they should be here any tick of the clock.  Need to catch up with Brenton over the week end a…[Read more]

Nice pics, looks  a great cruise.

Nice work mate, progress is progress

I am thinking of going to the Red Centre Nats this year (if the bloody car is ready!!)

Looks like i have a bit of catching up to do!!  So whens the next event?

Just catching back up on the forum, making nice progress there fella!!

Should “move” to SA for the build. No BS weight vs capacity crap here 

Hi Chris,  I dont think so, my printer will do basically a volume of 275mm x 275mm x 275mm.  Its something though that people like Rare Spares should be looking at….

Sure can, but I need to get hold of a dash surround to work with so I can design it and test fit it.  If anyone can post me one or drop one off to me happy to do one.

I am assuming its quicker with a passenger now dues to weight distribution not weight if ya know what I mean?  Lighter is always better isn’t it on a race car?

I am a little surprised tbh they dont make them out of CF.

Yea saw them too Cav, instantly thought of you two actually…

Yea gotta be happy with that, they have done a great job there, nice work.

Whats the story here, light weight bonnet?

Finally some progress to post about

Machining is all done, just picked it up.  So bored, honed, line bored, decked, new can bearings.  Crank ground, new reluctor wheel.  Looking forward to getting it home and on the engine stand and giving it a good clean up.

The cam has arrived from Cam Motion, I think you could say its going to ha…[Read more]

Finally some progress to post about

Machining is all done, just picked it up.  So bored, honed, line bored, decked, new can bearings.  Crank ground, new reluctor wheel.  Looking forward to getting it home and on the engine stand and giving it a good clean up.

The cam has arrived from Cam Motion, I think you could say its going to ha…[Read more]

Nice.