CommodoresPlus

Reported. Admin if you would be so kind to show adelajeffery the door.

If it was huge HP then no question. Mine is only a stocky with a bit of work nothing special.

I’ll talk to the trans shop soonish and see how we go. I will let you know the direction I end up taking though. Watch this space……… and this one too.

Taylor Conole? Such a tuff looking rig.

Taylor Conole’s old clubby? Such a tuff looking rig.

my VS has a 4L60E (8HBD) with a 2 Piece case (Factory 1998 VS Transmission-same as used in the VT)

Holden swapped to these sometime during 1997

checked ebay and there is a 7HBD which is a single case trans for v8

there are other 1997 v6 one’s on there which some are single and some are 2 piece

Maybe when VT was released?

my VS has a 4L60E (8HBD) with a 2 Piece case (Factory 1998 VS Transmission-same as used in the VT)

Holden swapped to these sometime during 1997

checked ebay and there is a 7HBD which is a single case trans

Maybe when VT was released?

my VS has a 4L60E (8HBD) with a 2 Piece case (Factory 1998 VS Transmission-same as used in the VT)

Holden swapped to these sometime around the 1997/1998 mark, not sure what a VS 1997 transmission has

my VS has a 4L60E  with a 2 Piece 8HBD (Factory 1998 VS Transmission-same as used in the VT)

Holden swapped to these sometime around the 1997/1998 mark, not sure what a VS 1997 transmission has

Yeah will speak to them. Hopefully yours has everything I want and it ends up being drive in and drive out. I think the trans is the same as mine.

That is about the figure I’m looking at for my rebuild $2.5-$3k. Its the electronic trans 4L60E in mine (i think that is what is in these). So they would be around the same price, but I always allow for more just in case. It has a shift kit in it but want to make sure it’s all good, no manual valve body. Just rebuild and strengthen what is there.…[Read more]

That is about the figure I’m looking at for my rebuild $2.5-$3k. Its the electronic trans 4L60E in mine (i think that is what is in these). So they would be around the same price, but I always allow for more just in case. It has a shift kit in it but want to make sure it’s all good, no manual valve body. Just rebuild and strengthen what is there.…[Read more]

Yeah, would be interesting to see what your trans spec is. Who did yours?

Thanks for the offer of the stall but think would be too high for the cam in it. If the trans has the work done that I want in mine it could be an option. Have been recommended a 2300rpm stall for mine. But if Norwoods say otherwise then I’ll let you know.

It isn’t…[Read more]

Looks awesome. Great for a home spray job.

Sold……….

price drop to $20