CommodoresPlus

How’s it coming along, you far off from a full tune?

Your pwr radiator did you go with a 55mm core or the larger 68mm?

copy that, cheers guys. ill be re doing that section in hard line 

aeroflow 100 series stainless braid hose, its what i had laying around so hopefully it holds up. i did think about doing stainless hardline as it exits the TH400 casing to behind the wheel arch and then the 100 series hose.

Heron, did you happen to have a photo of how you routed your transmission cooler lines as they come out of the TH400?

I have been re doing alot of work lately and i ended up routing my -6an lines in between two of the primary pipes, and then p clamped on the outside of the chassis rail / behind the drivers wheel area. Its awfully close to the…[Read more]

Hey Cav, coming along real nice!

Will you ever be looking at options to try keep the blower under the hood?

I seen on some US forums kong performance have released a tvs2650 rotor pack basically in a new case cast by edelbrock with the same dimensions as the lsa 1900 casing. sounds like the original Zl1 lid fits the blowers but what caught my…[Read more]

Hey Cav, coming along real nice!

Will you ever be looking at options to try keep the blower under the hood?

I seen on some US forums kong performance have released a tvs2650 rotor pack basically in a new case cast by edelbrock with the same dimensions as the lsa 1900 casing. sounds like the original Zr1 lid fits the blowers but what caught my…[Read more]

I’ll be watching this!

Do you know if the lsa is going to fit under the bonnet without having to cut a hole or run any type of scoop?