CommodoresPlus

VR or VS Caprice Seat trims Would be good, impossible to find a good used set

price list now added

yeah im in the same boat. my engine is a fair step bit different from original though so im going to speak to the tuner soon and see what he suggests, will probably will end up getting it towed down to him in st marys and get a basic tune done to run everything in then take it back there after a few months once its all run in, get proper tune…[Read more]

passenger side on the 1 3/4 competition set ran parallel to the chassis rail, with no clearance with the gasket off.

normal  1 5/8 set aren’t quite as bad. but has clearance with gasket on, so should be ok

my towbar runs a brace on the inside of the boot floor, from the very back of the car to the bump in the floor where the diff is. approx…[Read more]

i’d doubt the car would need a tune for  just the 70mm throttle, but if its got  new cam might as well tune the whole lot properly

hope you trial fitted the extractors before ceramic coating, them i had heaps of issues with the the one’s i was fitting to my 355, bought 3 sets in the end, originally had 1 5/8 primary type on it when it was a 5lt, so when i was planning to fit the new engine, i sold them off and bought a set with 1 3/4 primary’s.

First set was competition type…[Read more]

hope you trial fitted the extractors before ceramic coating, them i had heaps of issues with the the one’s i was fitting to my 355, bought 3 sets in the end, originally had 1 5/8 primary type on it when it was a 5lt, so when i was planning to fit the new engine, i sold them off and bought a set with 1 3/4 primary’s.

First set was competition type…[Read more]

not too sure then, im in SA

i suppose that would depend on what state your in

i’ve actually got a spare set of the Aeroflow transmission fittings. in the shed if your interested, i bought 2 packs didn’t realize they came in packs of 2, so there brand new and unused

and yes they come VERY close to the Trans Tunnel

if anyone needs aeroflow fittings, i have heaps left over from my VS, will get a list up in the next day or 2,…[Read more]

yeah that’s what I liked about it, had to drop the coolant in my mates Vt last year, due to a faulty new radiator (slightly leaking) had to do it twice as the relplacement lasted about 3 weeks after that

I did spot a radiator drain plug with a ball valve and barb on it. So might go that way

hey cava, just a quick question about your old VR, you fitted a drain to the bottom radiator hose, what did you use?