CommodoresPlus

WHO does the shaving? They turned out great. Wouldn’t mind doing mine. If that’s the case

Hmm wonder how I’ll fair, to urekon the and and exo gear would add up?

Mine has half cage and intrusion bars so should be similar. I got a bulky ass t400. Engines should be similar weight.

Your wheels would be a lot More then mine. Hmmmmm

Fark.

I was hoping to get down to 1400ish. Based on that I don’t think I’ll come close. 

Full race car now.

Whats she weigh in at?

Yours don’t seem to have all the bolt holes in them.

Love this car more and more when I see it.

What valve covers are they?

Fuck that

Long wheel base.

Nice.

Did you retain traction control to all 4 wheels?

What was the go?

Thank you for your contribution.

BUT

we don’t give a fuck. So fuck off.

Yeah i will just cap it. Or hide it.. The filter on this only vents if there is too much pressure and the pcv can’t keep it. It has a one way valve built in.

Bit like an air admittance valve.

Just going to hide it for now. I will always run this can on street. It doesn’t vent to atmosphere unless the pcv can’t keep up.

Ill just make it look like it’s connected properly when. I go engineer

With kframe spacers and a ctsv lid it will fit under the Bonnet.

But I think the ctsv kids are ugly. I used to have a cowl, the more and more I seen them the more I hated them.

Sunday car goes to my mate to start the wiring. Found out the Painter is in hospital. So we will make a start with all wiring from engine bay back.

No spacers. Bonnet would be 5-10 from the underside of the group a scoop.

Throttle body had to be installed upside down to fit also.

Few more parts starting to arrive. Moroso Battery box came today as well as my OKC fuel rails. 👌👌👌

Car is going to mates house on weekend so we can get a start on the wiring side of things. 👌

What made you go reverse?

I would from either tuff car parts or aftermarket industries.

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com.au%2Fulk%2Fitm%2F262009924739

You could call these guys. THey sell the whole assembly inc a Walbro.

That corvette filter/reg goes outside the tank.

Yeah that makes a masssssssive difference. I never seen them before. Aside from the ones to suit the round carby type filters.

Do you know of a 5inch inlet filter but the equivelant size to yours?

Been doing some reading in the states and they are getting great gains by going 5 inch.

I’m piecing bits and pieces together. Got my MAF card and b…[Read more]