CommodoresPlus

They get covered by the factory plastics. Can’t tell they are even there.

They are a nice bit of gear. Was there a need to go that big in the lift? Streetability comprimised?

Im all about cheating lol. I like that

Not sure mate, few more weeks at my mates for wiring i would assume. Then i have to book it in and get the bay smoothed and painted.

THEN

assmble everything.

They are like 50lb from memory. Soon as you pulley up you will come very close to max cycle.

Like any engine, too big and it makes them difficult to tune and run nicely

Damn. I need parts from Usa. Should bundle them.

You won’t get that “rumble”from a v6.

Just buy an off the shelf system, somthing like a red back setup etc. Cheaper, easier and basically the same. You can install it all your self.

FYI only need one thread about the same topic 👍

Once the fuel system and water pump are in and terminated it will get sleeved.

Fuck they are killer photos.

Some laminated a3’s in the shed, next to the photo of me and my car would look killer. 

That’s ok. I can’t get them anytime if your still keen in future.

Basing al my info on what all the fast yanks do. Around town the interchiller is good. But for all out performance at the track the Ice box reigns supreme.

If you keen on an EMP mate let me know. I’m going to be doing an order for another bloke in the next week. If that’s the case I’ll buy 2.

I wouldn’t bother with the insulation plates. All the yanks seem to think they are a waste of cash.

If you do choose the EMP. Go the biggest line you can. 1inch feed and return is best. -12 everywhere else.

Nice work mate.

100% go with a Reprogrammed EMP. You wont buy a better pump. If its something you keen on, i can get them from a mate of mine in USA. They are around $650-700 depending on the AUD.

That’s what i’m using along with a boot mounted ice tank.

You will find with a better pump and reservoir you will be able to go back up to to the…[Read more]

Price habib? Or I’ll ban you 

Done.

Hell yeah. That was a slight improvement.

Coils on the valve covers. If so I have a brand new set off an lsa u can have for $50

Haha yeah. Damn straight. They will help.

Lovely job.

He should give you a detailed spec sheet once done.

Jump on HSV & HDT enthusiast FB page. Will sell a lot easier and quicker there.

Check the internal rubber return hose is still intact and connected