CommodoresPlus

Mines all seperate sizes between the series so it’s all good. Once made. Should never have to touch again

Cost vs ease of use and simplicity for me is a no brainer.  You end up with one series of unused parts not 3.  Just my opinion. To each there own.

I went:

200 fuel and brakes

400 water

100 trans

Cost is the only issue.

I have a mixture of Teflon, 400 push lock and 100series on mine.

Hard to find a reason to not go Teflon everywhere.  Easier, smaller in every case imo.

im guilty of that. ALOT

Looking sweet mate.

Floor looks very cool, pardon the pun!

Already have one fire breathing monster, this one is all about reliability and cool factor

Hot again today, but more progress.  Unfortunately have to head back to work a week early, so this week we will see the end of the daily assault.  Happy with progress so far though.

So turned it around on the hoist  and time to tackle the long si…[Read more]

Lucky you consulted the forums number one automotive engineer.

Lol, I know right.  I think yours might be a little faster than Walter when it’s finished though IJ

Not sure what you mean. But the inlet and outlet are top and bottom ATM

???

Or you talking about the trans cooler?
then instructions said either up or too the side. Never face down??

Not sure what you mean. But the inlet and put are top and bottom ATM

???

Nice work.
Where your in the sport that you are $770 is small price to pay.

Smashing it mate.  Must be getting close?

Yea I know .I stand back and go great that’s done. Then see about 50 more jobs that need doing.  But slow and steady wins the race.

One new corner repair done and dusted. Super happy with how it turned out.  Haven’t flattened the spot welds on the rear inside where the rear hatch goes, but can do that later.  Took my time to “massage” it to get all the seams to line up.  Definitely welding has so much to do with preparation.  If everything is clean, aligned and tight, the wel…[Read more]

Wow, looks like Commodores Plus has its first 100,000 view thread.  Given I created this forum I am pretty bloody proud of that!!  (I know that’s self indulgent!!)

That’s a nice simple, elegant solution for the dipstick, good work.