CommodoresPlus

Yeah nice. I was looking for a PWR radiator and couldn’t find one. I know they used to do the conversion radiators. I changed from the el thermos to the au one and with the fans offset I think it will do the trick. I’m just about through that defect list I got for the rwc so I can start the engineering process.

Congratulation Cava.

What thermo fans have people run in there conversions? I know most use the AU thermo fans is there any other good choices? My current radiator doesn’t allow much room for an intake pipe.

HI All,

Last Wednesday i took my Calais down to start the RWC check before i send it to the engineer. They only found 8 items fr me to rectify. I have completed 5 of the items so far. below are the items.

1 Engine mount bolts to K frame as they were not 8.8 grade. Changed.

2 fix front brakes. They were grabbing on the front. Fixed

3 Oil leak.…[Read more]

Hi All, i thought i would post an update, my car is booked in tomorrow to have the sunroof replaced. I am getting it changed from a manual pop up to a electric. I had to get it replaced as there is no spare parts available for it after that it will go down to the panel shop to get the rust in the boot floor pane repaired near the back panel. Once…[Read more]

Hi Gtrboyy my Calais steering wheel the top was loose and has had the injection before. I changed to a smaller wheel also as i am tall and the original wheel hit my legs. I was thinking of making my own air box. I have a 5lt top and its not right for the intake.

Hi Cava, My engineer said to me as long as it is in a place that it will not get…[Read more]

Hi All,

Just an update, i am still getting the car ready for the engineer shouldn’t be too much longer. Just working out what to do for my air box.

Hi All,

Just an update, i am still getting the car ready for the engineer shouldn’t be too much longer. Just working out what to do for my air box.

Just an update. i have completed the vy window switch conversion.

Can your printer make the rear roof lining trim?

Cheers chris

Hi All,

Thank you, i might have to give that a go.

Hi All,

Just an update i have go the speedo to read using the LS1 ecu out put. I just need to check if it is accurate.

I cut a shifter down to fit my VN

Hi All,

Just a quick update i got the car driving and took it to a mates house to start the exhaust. I can see im going to have an issue on the drivers side as with the car sitting on concrete i have 102mm clearance to the flange.

Hi All,

Thank you for your reply, i will look into the digital dakota box.