CommodoresPlus

So I have seen a few valve spring tools and though I’d try this one for shits and gigs, but hey if it works it works.

Immortality I’m not looking forward  to getting it back on

Gary, I thought about buying one like the top one but wont use it enough. So I think I will buy one like the second one. I thought i would start a review thread because I have used shit pullers before that have snapped.

Hahaha cava.

Quality can take time. They will be mint when they are finished

With the horn going off you might have a dodgy switch in the door.

Hi chloe. Welcome to the forum.

I finally have all my parts beside the pushrods. I’m going to order them after I take a measurement. Now to find some time to get this swap going.

The gauge mounts look mint. I still have to get around to putting mine in.

Yeah that’s right mate. At least I will know the increase now that I have a base.

I just thought with the manual and 4.11 gears it might have made a bit more. I would rather be on an accurate dyno the one that fluffs the results.

The motor has done 227kms. It is a completely stock motor with no tune done to it. But yeah I would have thought it would have made more as well. The only this it has is extractors and pod filter.

I got my valve springs and oil pump today so not many parts left to collect before I do the cam and tune.

Hopefully the pan doesn’t leak again.

The heads are looking good.

I had my car on the dyno today so I can get a before cam power figure and it made 168rwkw I was hoping for a bit more.

Hey mate I’m in vic. If your after the diff it sold on the weekend.

Very good info

Where did you get the shims from

Very interesting Gary.