CommodoresPlus

Looking good! Hurry up already

Looking good mate some serious progress!

Would it be as affective on other side of rad tho? As draws air through the radiator may not work as well as cant seal it off properly like you can from other side?

Looks good, doesnt boxing rails like that cause issues with engineering etc? What kind of power you chasing?

That sucks so many threads useless now

Nice work looks bit more pro than my one haha, can imagine someone oneday pulling my one out thinking what butchery is this

True but i think i dont go to car meets and when i do never pop bonnet lol. I drive my car weekly, gym, dinner, parties etc. I built it to drive not stair at and keeping bay clean is a pain in the ass. After two years my paint still perfect, i am careful where i park etc.

I dont think the caddy top is that bad, just paint it etc. End of the day how often is bonnet even up, waste of time you dont drive around with bonnet up lol

Is it just me or is the trans mount bracket kind of flimsy looking? Swear every time i do my interior i have left over screws. And fits slightly differently togther every time

Nice, love the front bar think its the same as what was on the blown momo vs ute.

I look at it this way, if i make say 500+ for a days work and i can pay someone todo something say 300 and it would take me a day i am better off paying. Especially if its an annoying fiddly unsatisfying job. Lol recently payed to have auto oil and diff oil done on this very theory

Lol its going to be loud

Haha cheers you always see me at chapel lol. Went for lunch with the missus. Yea thanks mate believe it or not the car was about as dirty as it gets haha. Its defiantly not stealth thats for sure

What about just simple vents in top of the bonnet where the air box sections are. Not a raised scoop.

Not sure about those!! Ruins lines of the  car I think

How much for the hydro peddle box? They were fetching pretty big coin second hand when i looked into the conversion

So i take it you are sending me a quote?

Wouldnt go that far for a home made job way better than any ebay etc jobs i have seen for starters not a single welf is seen its all made seamless.

Yea me and the lads talked about it for a while, as its crazy how cheap shit can be done os.  But to do it right you would need to go there with the manifold to where they manufacture, not something you could do over skype etc

However i genuinely want one for my manifold just need to figure out how much it will cost and if worth it. If only a…[Read more]

Cheers i have someone with a plenum in NZ hope i can get it scanned, email me file and then send to someone to make. Even thinking china, as would be far cheaper. Time will tell, it may not be feasible tho

Brake upgrade lol guessing its drums on rears etc?