CommodoresPlus

Some nice parts going into it mate, been thinking of getting those coil overs for my ute, so can run a wider front tyre etc. They do a solid axle coil over as well.

Love the build mate following it closely. Wouldnt mind your brakes as well haha

Is that the standard centre console? I thought they only had them in the utes

Yea as in the ute no rear demister so i have the hsv security light button where it normally has an ugly blank plate. I then drilled out the standard flashing light and replaced with my alarm flashing light which is blue.

Lol are they what i think they are

A mint stock wheel is worth a fortune and not many after market suit a vs, was closest I could find that has crash pad. Was not meant to have red stitching.

over all very happy with interior as pretty much all brand new now

So must nearly be done then 

Guessing you will be busy over xmas with it so its done by feb

So fitted one of the trims, realised the brand new door vent i purchased off ebay was not 25i but 15i. So thought stuff it, set the boys up at work and went to two pick a parts, first one had bugger all 25is but managed to get heap of the plastic door plugs and screws. Second one had bugger all 25i’s and just as i was giving up hope i found it, a…[Read more]

I think he owns and runs that site?

Yea sweet what bags did u put in? U can get rear coil overs for ute. What brand coil overs?

Now to get it to drive like a new car!!! Drives like poo

Thanks hahah my interior is all pretty much brand new, its actually nice to sit in, not looking at stains or damaged interior parts etc.

The black interior parts has worked well with the 25i colour codes

New trims have finally been finished, had the colours changed from 15i to 25i and had the arm rests done in black leather. Should look good as have black carpets and plastics in the ute.

Does it have a shift kit? When my box was set up really aggressive it was like that but thats done with line pressure i think

Activity is what keeps it alive, eve if its rubbish activity no one wants to post if no one will reply etc just commodores is very busy so i dont think forums are dead. Over moderating can kill the forums and lack of people with knowledge. Vn ss forum died as well i think because all they cared about was fb

Shame if it were not for sc would never of done my ute!!

Fb is useless, any one can be an expert on there. The forums are more personal and you know who is an expert and who thinks they are.

yea Jc is strange as in you get a ban for even mentioning another forum. Useless for tec info tho

We cut my lines where they sweep under the box, and then have a rubber line clamped on, so i can remove box with lines attached

What is the pneumatic cylinder for?

On the twin throttles and after market i think people get them tapped in and run a dash fitting. Correct me if i am wrong

I ran -12 for all my catch can stuff, but nothing from valley just from rocker covers, however know few guys running the valley as well.

Did you do the door trims your self? How did you do it, very neat!!

No but this guy can as he made it, and its a perfect fit, i literally had to just cut front and back of the tunnel a bit here and there after removing the standard auto mount plate. I was careful to note where the stick was in drive so could then make sure i positioned the box the shifter would sit in that same position