Trans Cooler/cooling system

[ASPO355Participant AdelaideVN SS View build HERE Member since: October 23, 2015 Posts: 6]

Anyone know what the B&M trans coolers thermostat is set to?

[Anonymous View build HERE Member since: January 1, 1970 Posts: 0]

180F/82c

[ASPO355Participant AdelaideVN SS View build HERE Member since: October 23, 2015 Posts: 6]

Cheers mate. Im seeing 195f then the temp starts to drop.

[Anonymous View build HERE Member since: January 1, 1970 Posts: 0]

ASPO355 wrote:

Cheers mate. Im seeing 195f then the temp starts to drop.

There will be a bit of lag before you see an effect as it’ll need to flow xx amount of Oil through the cooler before the temp will drop..

[exec24Participant 2004 VY S2 Berlina 1996 VS 5L Sedan View build HERE Member since: April 8, 2015 Posts: 435]

rather than start another thread, i’d thought i’d just ask here again

Would anyone know what thread are the inlet/outlet on a 1998 VS Series 3 v8 Transmission (aka a VT 5lt transmission —8HBD) i’m not sure if its NPT or NPSM or something else entirely

i need a fitting like i’ve listed below as i have noticed i kink in one of the lines that i bought, where one of the flare nuts attaches. Considering this was the only set i’ve found when i was looking for them. im just going to cut them back and run some flexible braided line on the last 150-200mm where they go into the transmission. which will probably make it easier to fit them too.

https://www.aeroflowperformance.com/fittings/adapters/trans-cooler-fittings/af375-06blk

https://www.aeroflowperformance.com/fittings/npt-fittings/npt-to-straight-male-flare-adapters/af816-06blk

[Author]

Posts