Klampyz Vr round 2

[klampykixxParticipant Coffs HarbourFord Econovan View build HERE Member since: May 16, 2015 Posts: 167]

Hi guys I thought I’d load a space for my commodore.

 

Keeping this one as a track hack after the van is v6ified and is then capable of dragging this one around

Has complete vs conversion,  only thing vr left is body /badges/ rear axle. Everything else is vs.

Engine is 40 thou over,  has a Crow cam and springs, balanced bottom end and some lower Compression pistons fitted. It was built for boost but never got it so I’m thinking maybe a blower,  but could go turbo..  Really don’t know yet.

Anyway here’s a picture.

 

[VRSenator065Participant Adelaide SAVR Senator LSx454 1960 Kombi (project) 1921 Nash Hot Rod (future project) View build HERE Member since: February 17, 2015 Posts: 5 777]

You have some nice toys

[klampykixxParticipant Coffs HarbourFord Econovan View build HERE Member since: May 16, 2015 Posts: 167]

Thankyou sir,

As do you!

[VRSenator065Participant Adelaide SAVR Senator LSx454 1960 Kombi (project) 1921 Nash Hot Rod (future project) View build HERE Member since: February 17, 2015 Posts: 5 777]

Who dies with the most toys wins!!

[thatotherguy94Participant VS Acclaim, VZ SSZ Ute View build HERE Member since: March 2, 2015 Posts: 189]

Looks pretty good, is that a VT SS front lip?

[klampykixxParticipant Coffs HarbourFord Econovan View build HERE Member since: May 16, 2015 Posts: 167]

It is, it doesn’t fit 100% but I like the look of it on there. Its a touch short at the wheel arch, about 1cm or so on each side.

Hoping to find some BA xr skirts and rear bar lip like I had on my old vr before I moved it on.

[klampykixxParticipant Coffs HarbourFord Econovan View build HERE Member since: May 16, 2015 Posts: 167]

Here’s a shot of it on the old car,

 

[rad91Participant View build HERE Member since: September 10, 2016 Posts: 2]

How good did the xr skirts fit on back and sides? Much effort to get em good?

[klampykixxParticipant Coffs HarbourFord Econovan View build HERE Member since: May 16, 2015 Posts: 167]

the rear bar clip was actually slightly too narrow as the falcon tapers down quite a bit, where the commodore is quite square in the bum, i had to cut it in the centre, left about a 3″gap in the centre

 

i screwed it on because i didnt care about the visual, but some good glue and it would be there permanently.

the side skirts were too long, as you can see by the XR badge being right at the end.

 

i did have to trim alot of the stock falcon mounts off to make it sit right, wasnt hard to do tho.

 

i think it will suit the VTSS front lip quite well.

[Author]

Posts