Home›Forums›Technical – General›Engine Conversions & Engineering›Fitting VL GPA TTB to VS GTS advice

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of cava454 cava454 5 years, 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 5, 2019 at 6:15 pm #28539
    Profile photo of Craig
    Craig
    Participant
    Member since: August 4, 2015
    Posts: 16

    Hi all.

    i have a VS GTS and a VL GPA Walkinshaw twin throttle body manifold with the rocker covers.

    Has anyone fitted these to a VS before? Just wondering how smoothly it went fitting it all?

    Also I would like to fit a VN GPA airbox I can get a top part of the airbox without the bottom. Would anyone know if the VS HSV base airbox will accept the VN GPA top part?

    Thanks

    May 5, 2019 at 6:19 pm #28541
    Profile photo of cava454
    cava454
    Moderator
    Member since: February 20, 2015
    Posts: 2 390
    Supporter

    Bolts on like any other manifold. Just use the correct procedure and sequence and al should be good.

    The top section requires the specific lower section from memory.

    Be sure to post some snaps 👍

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.