Home›Forums›Technical – General›Car Audio & Electrics›Dash cluster swap
This topic contains 7 replies, has 2 voices, and was last updated by klampykixx 8 years, 1 month ago.
-
AuthorPosts
-
October 27, 2016 at 11:40 pm #20355
klampykixxParticipant- Coffs Harbour
- Ford Econovan
View build HERE
Posts: 167Hi guys,
I’ve been looking at the angry spaghetti monster I’ve got from within my vx I stripped.
Can I retrofit a vs style dash cluster to work with the vx style bcm?
I haven’t checked it yet but I’d bet a vs style cluster would pretty nicely fit in my vans dash. otherwise I’m up for a full custom/modified cluster and I’d rather avoid that if I can just mount a commodore cluster.
October 27, 2016 at 11:41 pm #20356
klampykixxParticipant- Coffs Harbour
- Ford Econovan
View build HERE
Posts: 167Also I can set the Ks to suit the vans if I can go with an earlier cluster.
October 28, 2016 at 12:20 pm #20371
VRSenator065Participant- Adelaide SA
- VR Senator LSx454 1960 Kombi (project) 1921 Nash Hot Rod (future project)
View build HERE
Posts: 5 777Not sure if this is exactly the same but in my case I have a VY ecu mated to a VR/S cluster, but the BCU is still VR.
October 28, 2016 at 7:42 pm #20381
klampykixxParticipant- Coffs Harbour
- Ford Econovan
View build HERE
Posts: 167Ok I didn’t think it could work like that.
October 29, 2016 at 1:28 pm #20384
klampykixxParticipant- Coffs Harbour
- Ford Econovan
View build HERE
Posts: 167so im going to be running a VX BCM and want to try wiring up a VS style cluster, assuming it fits in the hole.
if i match sensor wires, and warning lights etc, in theory, will it swap over?
November 3, 2016 at 8:49 am #20427
VRSenator065Participant- Adelaide SA
- VR Senator LSx454 1960 Kombi (project) 1921 Nash Hot Rod (future project)
View build HERE
Posts: 5 777Hey mate, Dan btw is the guy that did my cluster for me, a bit of a guru when it comes to what can be done. This is his fb link
https://www.facebook.com/profile.php?id=100011363536018
November 6, 2016 at 12:02 am #20459
klampykixxParticipant- Coffs Harbour
- Ford Econovan
View build HERE
Posts: 167Hopefully getting a vr cluster this week, so first job will be making it physically fit, second is to wire it and make it all work with vx bcm.
I figure the 4L60e ran the same speed sensor so it should talk the same way.
November 22, 2016 at 9:04 pm #20700
klampykixxParticipant- Coffs Harbour
- Ford Econovan
View build HERE
Posts: 167got around to test fitting the VR cluster. and its a fail. too big and no way of fitting it in unless i hack a good inch out of each side of the dash. so no commodore dash in my van.
-
AuthorPosts
You must be logged in to reply to this topic.